- Firstly, save
any show data in the console onto a floppy disk.
This is very important as any data in the console will be lost.
You have been warned!!!
- Switch the console off
- Lift up the top panel on the
console after undoing the screws.
- Locate the WipeAll link on the
Borris motherboard (see photos below).
- Fit a jumper across the two pins
and turn the console on.
- Wait until the console
has properly initialised (about 10 seconds max) and then switch OFF the
console.
- Replace the jumper onto one leg of the link, close the lid and tighten the screws by turning one-quarter turn clockwise.
- Power ON the desk and reload your show from your backup disks.
There is now
an alternative method of performing a WIPEALL without having
to open up the console. To do this you must be running the
latest software on your console.
Click here
to go to our Download site to check what the latest version
for your console is.
This feature
is available on Azure, Pearl and Sapphire consoles but is
NOT yet implemented on the Diamond II and III's.
-
Press and hold preset ADD buttons 21 and 30, then switch ON the desk.
(Playback buttons 21 and 30 on the Azure)
-
The desk will enter the AVOS menu (AVOS date must be June 2000 or later)
-
Press 1 then hit ENTER to start and execute a wipeall.
 |
