To do this you must ensure that the fixtures have been recorded 'BY CHANNEL' so that one chase does not interfere with the other.
It is however easy to convert a chase which has been recorded 'BY FIXTURE' to 'BY CHANNEL'.
Following the steps below :-
- Photocopy your chase to a spare playback, then if you don't like the results you can easily go back to the original
chase(s).
- Now for each chase do the following
:-
- Turn the Key to Program
- Press UNFOLD
- Press the playback SWOP button above the chase you wish to modify.
- Select the fixture you are using in the chase.
- Switch OFF the attributes that are NOT required in the chase. These will be the attributes you are moving from another chase. You do this by pressing the ON/OFF button so that the green LED in the ALIGN button is ON, and the red LED is off.
- Finally press softkey A
'RECORD'
button followed by the playback SWOP button for the first step.
Repeat this for each step.
- To close the chase press the UNFOLD button again and press CLEAR twice.
You may need to do this for all the chases you are expecting to run simultaneously.
|
