- Power down and remove the mains connection from the Rack·
- Remove the module (unscrew the two M6 Pozi screws on the module)·
- Remove the patch output panel (the panel with the socapex or harting connectors)·
- Fit the Rib to the back of the connector panel using the four supplied rivets.
A - To be drilled
after the other 4 holes have been riveted
B - Bay 1 hole,
rivet only
C - Bay 2 hole,
rivet only
D - Bay 3 hole,
rivet only
E - Bay 4
hole, rivet only
- Drill the 5th top hole from the back with a 4mm drill
- Rivet the 5th hole
- Alternatively M4x16 screws and Nyloc nuts can be used instead of the 4mm rivets
|
